Before Usingyoursewing Machine; Controlling Sewing Speed - Sears Kenmore 385.19110 Manual De Instrucciones

SECTION 2. GETTING READY TO SEW
Connecting the Power Supply
1. Turn the power switch OFF.
2. Insert the foot control plug into the machine socket.
3. Insert the machine plug into the machine socket.
4. Insert the power supply plug into the outlet.
5. Turn the power switch ON.
8. The LED display wilt show "01" (straight stitch)
after one second.
_ Power switch
_ Foot controll plug
_ Machine socket
_ Machine plug
_ Power supply plug
_ Outlet
Before Using Your Sewing Machine:::::::
Before usingyoursewing machine
place a piece of waste fabric
foot and run the machine with _d for a
minutes. Wipe away any oil_ _mayappe_
* While in
sewing .....
as the thre_ ta_e-up lever,
* Always tu¢ _i_e power swit _and unplug from
the power ....
-- When machi_ attended.
-- When att _pa rts.
-- When
* Do not place anyihi_ _ t_e foot control when not
sewing.
Controlling Sewing Speed
Speed control lever:
You can set the maximum sewing speed by the speed
control lever.
_ Slide the lever to the right for higher speed.
_ Slide the lever to the left for slower speed.
Foot Controller Model 21249 is used with Sewing
Machine Model 385.19110.xxx (xxx represents
numbers 000 through 999).
Foot control:
Sewing speed is varied by the foot control.
The harder you depress the foot control, the faster the
machine runs.
CAUTION:
Do not place anything on the foot control when the
machine is not in use.
Polarized Plug
This appliance has a polarized plug (one blade wider
than the other). To reduce the risk of an electric
shock, this plug is intended to fit in a polarized outlet
only one way. If the plug does not fit in the outlet,
reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do not
modify the plug in any way.
( ( _