Changing The Digital Display Battery - Fronius TIG Grinder Manual De Instrucciones

Changing the dig- A CR2032 battery will be required.
ital display bat-
tery
(6)
WARNING! Danger of injury or damage from incorrect belt tension or motor rpm.
Do not alter anything inside the device. Only carry out the tasks specified.
(1) (2)
Housing (left side)
(5)
(3)
Housing (right side)
Remove the left and right TX25
1
(1) - (4) screws from the housing
Lift up the housing cover by just
2
enough to disconnect the PE conduc-
tor (5) from the motor
Place the housing cover next to the de-
3
vice
Slide out the battery (6) and replace
4
with a new CR2032 battery.
Fit the new battery so that the negative
terminal is facing outwards
Connect the PE conductor (5) and
5
replace the housing cover
Refit the left and right TX25 (1) - (4)
6
screws on the housing
Tightening torque = 6.0 Nm
(4)
69