Grinding The Electrode - Fronius TIG Grinder Manual De Instrucciones

Grinding the elec-
trode
58
14°
(3)
1
(2) (1)
2
3
4
5
6
Open the knurled screw (1) and set the
angle adjustment (2) to the required
angle
– Read the set angle on the digital
display (3)
NOTE! The set angle corresponds
to half the tip angle.
The tip angle in the example
shown would be 28°.
Re-tighten the knurled screw (1)
Switch on the device
Introduce the electrode holder into the
guide bushing of the grinder
NOTE! Do not exert any pressure
on the electrode during the grind-
ing process. The weight of the
electrode holder is enough to run
the grinding process.
As soon as the electrode makes cont-
act with the grinding disc, turn the elec-
trode holder slowly
Grinding is completed when
- the cone of the electrode holder
touches the cone of the guide bus-
hing and
- there is no longer any grinding noi-
se
Remove the electrode holder and
switch off the device