Cutting The Electrode Tip - Fronius TIG Grinder Manual De Instrucciones

Cutting the elec-
trode tip
(A)
(1) (2)
3
NOTE! Electrode grinding can now start immediately. It is no longer necessary
to set the length.
Set the length stop to the tip length (A)
3
Insert the electrode holder into the gui-
4
de bushing of the length stop as far as
the stop
This accurately sets the length of the
electrode
Tighten the back part of the electrode
5
holder (3)
– This clamps the electrode in the
electrode holder
Introduce the electrode holder (3) into
1
(3)
the guide bushing (2) of the separator
as far as the stop
Switch on the device
2
Turn the electrode holder (3) and
3
slowly press the handle (1) down
– This cuts the electrode
Switch off the device
4
53