Start-Up; Safety; Setup Regulations; Mains Connection - Fronius TIG Grinder Manual De Instrucciones

Start-up

Safety

Setup regulations

-
-
-
-

Mains connection

The rating plate contains details of the permitted mains voltage and frequency and is locat-
ed on the underside of the housing. The device is only designed for these values.
The mains lead fuse protection specification must be appropriate to the device output. The
device output can be found on the rating plate and in the "Technical data" section.
The device must only be operated with the pre-fitted mains lead and mains plug.

Starting up

1
2
3
4
5
WARNING! Incorrect operation may result in serious injury or damage. Do not
use the functions described here until you have thoroughly read and understood
the following documents:
- these operating instructions
- the safety data sheets for the materials used, particularly for the electrodes
to be ground
Place the device on a firm and level surface
Position the device so that cooling air can flow unhindered through the air ducts un-
derneath and on the back
Ensure that the workplace is adequately lit
Do not use the device outdoors
NOTE! An inadequately dimensioned electrical installation can cause serious
damage. The mains lead and its fuse must be dimensioned to suit the local power
supply. The technical data shown on the rating plate applies.
Move the main switch to the - O - position
Plug in the mains plug
Insert the electrode holder into the guide bushing of the grinder to prevent the grinding
fluid spraying out
Switch on the device for approx. 5 seconds
The grinding fluid will spread through the device
Check the fluid level and top up with grinding fluid if necessary
49