Grinding The Electrode; General; Preparing The Electrode - Fronius TIG Grinder Manual De Instrucciones

Grinding the electrode

General

Preparing the
electrode
4
6
50
NOTE! To be able to grind an electrode, it must be at least 30 mm long.
The processing of shorter electrodes is described in the "Creating an electrode
shorter than 25 mm" section.
2
(1) (2)
(4) (5)
Insert the electrode (1) into the clam-
1
ping sleeve of the electrode holder
from the front
– Approx. 25 mm of the electrode
must still protrude at the front
Twist the front part (2) and back part
2
(3) of the electrode holder as shown
and lightly clamp the electrode
The electrode should then not be able
2
to slip by itself, but it must still be pos-
sible to move it by hand
(3)
Open the clamping screw (5)
3
Move the length stop to the zero positi-
4
on
Tighten the clamping screw (5)
5
Insert the electrode holder into the gui-
6
de bushing (4) of the length stop as far
as the stop
– This accurately sets the length of
the electrode
Tighten the back part of the electrode
7
holder (3)
– This clamps the electrode in the
electrode holder