Fronius TIG Grinder Manual De Instrucciones página 63

5
(4) (5)
(4) (5)
NOTE! The guide bushing (5) of
the grinder engages as it is turned
in 0.1 mm increments.
Unscrew the guide bushing (5) approx.
3
2 - 3 mm anti-clockwise (approx. 20 -
30 grid increments)
Introduce the electrode holder (4) into
4
the guide bushing (2) of the grinder as
far as the stop
This accurately sets the length of the
electrode
Twist the front and back parts of the
5
electrode holder (4)
– This clamps the electrode
Turn the guide bushing (5) anti-clock-
6
wise to set the required flattening of the
electrode tip
(e.g. 5 grid increments = 0.5 mm flat-
tening)
Switch on the device
7
Introduce the electrode holder as far as
8
the stop
Remove the electrode holder
9
Switch off the device
10
61