General; Device Description; Scope Of Supply; Proper Use - Fronius TIG Grinder Manual De Instrucciones

General

Device descrip- The device is used for sharpening and cutting the tungsten electrodes that are used as the
tion electrodes for TIG welding torches.
The angle of the tip is infinitely variable and is digitally displayed.
The separator allows electrodes of any minimum length to be created.
The flat side of the grinding disc is used to grind lengthwise along the electrode. This pro-
duces optimum tip formation.
A choice of 3 grinding tracks is available to increase the service life of the grinding disc.
The electrode holder accurately positions the electrodes for grinding. This ensures precise
and repeatable creation of the electrode tip.
There is a separate clamping sleeve for each electrode diameter; this ensures that the
electrode is securely located in the electrode holder.
The use of grinding fluid and a container avoids grinding dust emissions.

Scope of supply

In addition to the base unit, the following elements are included in the scope of supply:
(1)
(2)
(3)
(4)
(5)

Proper use

The device is intended exclusively for grinding and/or cutting tungsten electrodes. Any oth-
er form of usage is deemed "not in accordance with the intended purpose". The manufac-
turer shall not be held liable for any damage arising from such usage
44
NOTE! If required, ask the manufacturer for the material safety data sheets for
the grinding fluid.
(1) Handle for the separator
(2) M10 screw for the stop pin
(6)
(3) Back part of electrode holder
(7)
(4) Front part of electrode holder
(5) Length stop
(8)
(6) Clamping sleeve 3.2 mm
(7) Clamping sleeve 2.4 mm
(9)
(8) Clamping sleeve 1.6 mm
(9) Stop pin for 30 mm electrode
(10)
(10) Stop pin for 92 mm electrode
(11)
(11) Electrode guide 1.0 - 1.6 mm
Not illustrated:
- 250 ml grinding fluid
- 500 ml grinding fluid
- Electrode guide 2.4 - 3.2 mm
(already fitted on the back of the sepa-
rator)