Avidsen 114166 Manual Del Usuario página 51

Between the panels and the fixed parts close to each other
Depending on the configuration of the site where the motorised gate is installed, there may be confinement
areas between the panels in open position and the fixed parts close to them. To remove these areas, it is
mandatory to leave a safe distance of 500mm between the fixed part and the moving parts of the motorised
gate.
confinement
area
PREVENTING OTHER HAZARDS
The body of a switch with no lock must be located in direct view of the driven part but away from moving
parts. Unless it operates with a key, it must be installed at a minimum height of 1.5m and must not be
accessible to the public.
After installation, ensure that the components of the gate do not hang above a footpath or public access
road.
2 - INSTALLING ACTUATORS
The motor drive must be installed by qualified personnel, in compliance with all the indications provided in
the "General warnings."
Before starting installation, ensure that:
• Hazards can be minimised by following the recommendations under the Chapter "Hazard analysis."
• The desired use has been correctly defined.
• The gate complies with the specifications provided in the Chapter "Specifications of the gate to motorise."
The different stages of installation must be followed in order and in compliance with the indications given.
• Stops (not supplied)
This gate motor drive is a self-locking motorisation system. Your two-panel gate must be equipped with a
central stop and side stops (not included).
The (central and side) stops must stop the gate without locking it. In other words, any mechanical lock (or
latch) and any tilting shoe base or stopper must be removed.
hazard
post
view from above
C - INSTALLATION
solution
post
500mm
minimum
9 EN