Avidsen 114166 Manual Del Usuario página 55

Please note: It is very important to follow this step otherwise the gate may not fully open or close properly!
carriage
Assemble the actuator rotation axis with the post mounting bracket
Using a butterfly screw, assemble the gate mounting bracket with the actuator. Use the hole corresponding
to distance D (see table p.12).
Close the gate by pressing it securely against its central stop, then rotate the actuator in order to install
the base of the gate mounting bracket onto the gate. Then mark the location of the two mounting holes
on the gate.
Battery con-
48mm
5mm
brown
stop
free space
Rod movement direction
nection
blue
brown
blue
1
2
3
4
5
C - INSTALLATION
13 EN