Avidsen 114166 Manual Del Usuario página 81

1 - TECHNICAL CHARACTERISTICS
The technical characteristics are provided as an indication only and for a temperature of +20°C. The
company Avidsen reserves the right to modify these characteristics at any time, while under all
circumstances guaranteeing these products' smooth operation and the type of use intended, in an aim to
improve these products.
Type
Power supply
Nominal force
Speed at rated torque
Consumption at rated strength
Cable
Assigned operating duration
Maximum number of cycles/day
Operating temperature
Protection rating
Type
Contents
Power supply
Maximum assigned power
Motor output (- M1 + / - M2 +)
Flashing light output (- Warn +)
+12Vdc power output (+12V / GND)
Photocell input (GND / PHO)
Input for control device (2B / GND)
"2 panels"
G - TECHNICAL AND LEGAL INFORMATION
Actuators
24Vdc motors, reduction gear, type: worm gear
24Vdc
650N
2cm/sec
2A
50cm. 2 x 0.75mm2 section cables
10 minutes
50
-20°C/ +60°C
IP44
Electronic control box
Electronic control box for 2 x 24Vdc actuators
1 AVLO electronic card, 1 x 230 / 20Vac transformer
230Vac / 50Hz or 24Vdc
240W
2 outputs for 24Vdc motor
- Maximum output current at start for 3s = 3A.
- Maximum output current after start = 2.5A
Flashing controlled by the electronic card.
For 24V flashing light with LED only.
To power the photocells. 3.3W maximum
Input for dry contact that is normally closed
Input for dry contact that is normally open (closing the contact
triggers a command to set the gate in motion or stop it)
39 EN