Husqvarna TE 250 2005 Manual Del Propietário página 282

- Lubricate the drive chain and all the ca-
bles.
- Spray oil on all unpainted metal surfaces
to prevent rusting. Avoid getting oil on rub-
ber parts or in the brakes.
- Set the motorcycle on a box or stand so
that both wheels are raised off the ground.
(If this cannot be done, put boards under
the front and rear wheels to keep dam-
pness away from the tire rubber).
- Tie a plastic bag over the exhaust pipe to
prevent moisture from entering.
- Put a cover over the motorcycle to keep
dust and dirt from collecting on it.
To put the motorcycle back into the use af-
ter storage.
- Make sure the spark plug is tight.
- Fill the fuel tank.
- Run the engine to warm the oil then drain
the oil.
- Put in fresh transmission oil (P. 100).
- Check all the points listed under the in-
spection and Adjustment Section (P. 286-
292).
- Lubricate the points (listed in the
Lubrication Section P. 286-292).