Emc Information; Guidance And Manufacturer's Declaration - Electromagnetic Immunity - Stryker EPIC II 2031 Manual Del Usuario

Cama de cuidados críticos
Tabla de contenido

Publicidad

EPIC II CRITICAL CARE BED

Guidance and Manufacturer's Declaration - Electromagnetic Immunity

The Epic II Critical Care Bed is suitable for use in the electromagnetic environment specified below. The customer
or the user of the Epic II Critical Care Bed should assure that it is used in such an environment.
Immunity Test
Electrostatic Discharge (ESD)
IEC 61000-4-2
Electrostatic fast
Transient/burst
IEC61000-4-4
Surge
IEC 61000-4-5
Voltage
dips,
voltage
variations
and
short
interruptions on power supply
input lines
IEC 61000-4-11
Power frequency (50/60 Hz)
magnetic field
IEC 61000-4-8
Note: U
is the a.c. mains voltage prior to applications of the test level.
T
www.stryker.com

EMC Information

IEC 60601 Test Level
+6 kV contact
+6 kV contact
+8 kV air
+8 kV air
+2 kV for power
+2 kV for power
supply lines
supply lines
+1 kV for input/
+1 kV for input/
output lines
output lines
+8 kV differential mode
+8 kV differential mode
+2 kV common mode
+2 kV common mode
<5%Ut (95% dip in Ut) for
<5%Ut (95% dip in Ut)
0,5 cycle
for 0,5 cycle
40%Ut (60% dip in Ut) for
40%Ut (60% dip in Ut)
5 cycles
for 5 cycles
70%Ut (30% dip in Ut) for
70%Ut (30% dip in Ut)
25 cycles.
for 25 cycles.
<5% Ut (>95% dip in Ut)
<5% Ut (>95% dip in Ut)
for 5 sec.
for 5 sec.
3 A/m
3 A/m
2031-009-011 REV B
Compliance Level
Environment Guidance
Floors
concrete,
If floors are covered with
synthetic material, the relative
humidity should be at least
30%.
Main power quality should be
that of a typical commercial or
hospital environment.
Main power quality is that of
a typical commercial and/or
hospital environment.
Main power quality should be
that of a typical commercial
and/or hospital environment. If
the user of the Epic II Critical
Care Bed requires continued
operation during power main
interruptions, it is recommended
that the device be powered
from an uninterrupted power
supply or a battery.
Power
fields should be at levels
characteristic
location in a typical commercial
and/or hospital environment.
Electromagnetic
should
be
wood,
or
ceramic
tile.
frequency
magnetic
of
a
typical
Return To Table of Contents
2-29

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido