cecotec BOLERO DRESSCODE 10800 INVERTER A Manual De Instrucciones página 103

3. PRODUCT INSTALLATION
1. Place the device on a flat, stable and dry surface. Make sure the product does not stand
on the power cord.
2. Never install it on a soft carpet or wooden floor, or on any kind of mezzanine.
3. The washer may move a little during operation due to overload factors.
4. Avoid direct sunlight and ensure sufficient ventilation.
5. Keep the room environment dry and avoid humidity.
6. Remove the cardboard box and Styrofoam packing.
7. Free the power cable and the drain hose from the rear.
8. Remove any accessories that may be inside the drum, such as the water supply hose,
instruction manual, etc.
9. The washing machine should be operated within a temperature range of 5-40 °C. If used
under 0°C, the inlet valve and draining system may be damaged.
10. Install the appliance ensuring sufficient space around it (Fig. 4):
a: minimum 3 cm.
b: minimum 5 cm.
c: minimum 5 cm on the left side.
d: minimum 5 cm on the right side.
e: minimum 70 cm.
WARNING: do not allow metal parts of the appliance to come into contact with metal sinks or
other appliances.
Removing the transport screws (Fig. 3)
- The transport bolts must be removed from the backside of the device before using it.
IMPORTANT: it is imperative to remove the transport screws before the first use,
-
otherwise they may damage the drum during the operation of the device.
The transport screws will be necessary again when moving the product, so make sure
-
they are kept in a safe place.
In order to remove the screws:
-
Loosen 4 screws with a spanner and then remove them (A).
-
Remove the 4 tube spacers (depending on model) (B).
-
NOTE: during removal of the transport screws, occasionally the pipe spacers may fall into
-
the machine, if this happens, they can be accessed by tilting the machine forward and
picking them up from the floor or inside the base of the machine.
Cover the transport screw holes with the 4 supplied plugs (C).
-
Keep the transport screws properly for future use. You will need them again if the
-
washing machine needs to be moved to another location.
If it is necessary to transport it to another location:
-
BOLERO DRESSCODE 10800 INVERTER A/ STEEL A
ENGLISH
103