cecotec BOLERO DRESSCODE 10800 INVERTER A Manual De Instrucciones página 107

Perform the same operation to restore the sound.
-
D: STEAM
Press the button to add a steam wash process after the last water draining step of the
-
selected wash programme.
Some wash cycles cannot select the steam wash function. It can only be selected if there
-
is a steam icon in front of the programme name on the control panel or in the wash cycle
table.
E: RINSE
Select the rinse cycle, the rinse time appears on the digital display.
F: DELAY END
Press the button to set the end time of the washing programme.
G: ONE TOUCH
Press the button to set the "M-Smart" wash cycle.
H: START/PAUSE
Press and hold the button to start or pause a wash cycle.
Adding laundry during the execution of a washing programme
Once the wash cycle has started, press, and hold the START/PAUSE button again. If the
-
DOOR LOCK indicator light is off
out of the drum.
To resume the wash cycle from the point where it was interrupted, close the door, and
-
press the button again.
WARNING: if the water level or water temperature in the drum is too high, the door lock
-
indicator light will come on
I: STAINS
Press the button to select the type of soiling of the laundry, the washing machine will
-
automatically adjust the most optimal way to remove the soiling.
Up to 8 types of soiling can be selected.
-
M: Display (Fig. 14)
1. Temperature indicator
When a wash cycle is selected, the default temperature value of this programme will
-
appear on the display, with the temperature indicator light illuminated.
You can change the temperature value by pressing the TEMP button. If "- -" is shown on
-
, the door can be opened, and laundry can be taken in or
and the door could not be opened.
BOLERO DRESSCODE 10800 INVERTER A/ STEEL A
ENGLISH
107