cecotec BOLERO DRESSCODE 10800 INVERTER A Manual De Instrucciones página 106

ENGLISH
For added safety, you can also use a drain hose holder (not included) and install the hose
-
over a sink/washbasin or tank, as shown in Figure 11.
The use of hose extensions is not recommended; if absolutely necessary, the extension
-
should have the same diameter as the original hose and should not exceed 250 cm in
length (Fig. 12).
If drain hose is too long, do not force it into washing machine as it will cause abnormal
-
noises.
After installation, wait a few hours before operating the appliance to allow it to
-
acclimatise to the ambient conditions in the room.
Only connect the device when the installation has been completed.
-
4. OPERATION
Note
Before washing the clothes for the first time, the product shall be operated in one round of
the whole procedures without the clothes inside.
Control panel
A: Wash cycle button/selector
Used to programme the desired wash cycle.
-
OFF position : turn the wash cycle selector, when the indicator light below the symbol
-
is on, the machine will stop running and turn off. If the machine is switched off during a
wash cycle, the wash cycle will be cancelled.
B: TEMP (Temperature)
Press the button to change the water temperature of the selected cycle, the temperature
value will appear on the display.
C: SPEED
Press the button to change the spin speed of the selected cycle, the speed value will appear
on the display.
CHILD LOCK FUNCTION
When a wash cycle is running, if you want to activate the child lock, press, and hold the
SPEED button for about 3 seconds.
Sound cancellation (buzzer)
Press and hold the SPEED button and the ONE TOUCH button at the same time for at least
-
3 seconds.
You can cancel the sound during a wash cycle.
-
BOLERO DRESSCODE 10800 INVERTER A/ STEEL A
106