cecotec BOLERO DRESSCODE 10800 INVERTER A Manual De Instrucciones página 126

ENGLISH
The machine is
continuously filled with
water and continuously
emptied
The drained water
returns to the apparatus
Control panel gets hot
General issues
Do not repair or replace any part of the appliance unless specifically instructed to do so
-
in this instruction manual. It may lead to a dangerous incident that endangers your health
and/or damages property.
In case of fault or malfunction, contact the official Technical Support Service of Cecotec.
-
Use original spare parts.
-
IMPORTANT: do not come into contact with the following internal components while the
appliance is connected: inlet valve(s), drain pump, motor controller heat sink, PCB.
Errors
Error Cause
E02 No water in
E03 Drain failure
BOLERO DRESSCODE 10800 INVERTER A/ STEEL A
126
The top of the drain hose is too low. It should be installed at a
height of 65-100 cm from the ground.
The end of the drain hose has been pushed too far down into
the standpipe; the hose elbow must be installed 100 mm from
the end of the drain hose.
The end of the drain hose is submerged in the discharged
water.
If the end of the drain hose touches the discharged water
(water drained from the washing machine), it (the discharged
water) may be sucked back into the appliance and damage the
appliance or garments.
This is a slight heating effect of the electronic components on
the PCB board installed on the back of the control panel.
Your appliance contains sensors that monitor progress during
the wash cycle (e.g. water level, temperature, unbalanced
loads, wash time/progress). Normally, if your appliance
completes the cycle successfully, it is unlikely that there will
be a problem.
Solution
Check if the tap is open. If the water supply is cut off. Are the
mesh filter in the water supply hose and the water inlet valve
blocked? What if the water supply hose of the appliance is
frozen? Eliminate the above causes of failure. If the fault code
still exists, please contact the Cecotec Technical Support.
Clean the pump filter.
Check if the drain hose is bent, kinked, or blocked. Eliminate
the above causes of failure. If the fault code still exists, please
contact the Cecotec Technical Support.