cecotec BOLERO DRESSCODE 10800 INVERTER A Manual De Instrucciones página 118

ENGLISH
2. Close the door
Make sure that there are no dirty clothes between the door glass and the rubber seal. Close
the door, make sure you hear the "click" as it closes.
3. Open the tap
Make sure that the appliance is connected to the water mains. Open the tap.
4. Set the desired programme
Select the required programme with the washing programme selector. The duration of
-
the wash cycle is shown on the display. The machine automatically displays the default
temperature and possible spin speed settings for the selected programme. Adjust the
temperature and/or spin speed settings, if necessary, with the corresponding buttons.
Change the temperature, if necessary
-
Press the TEMP (Temperature) button to progressively decrease the temperature setting
-
until cold wash is reached ("--" will be displayed on the digital display). Pressing the
button again sets the highest possible setting.
- Change the spin speed, if necessary
- Press the SPEED button to progressively decrease the spin speed until the spin cycle is
switched off ("--" will be shown on the digital display). Pressing the button again sets the
highest possible setting.
Select options, if necessary
-
Press the buttons to select the desired option; the indicator light of the corresponding
-
option will turn on.
Press the button(s) again to cancel the option, the indicator light of the corresponding
-
option will go out.
If the selected option is incompatible with the configured programme, the incompatibility
-
will be signalled by a beep of the buzzer and the indicator light of the corresponding
option will flash.
If the selected option is incompatible with a previously configured option, only the most
-
recent selection shall remain active.
5. Add detergent
Remove the detergent dispenser and add detergent and fabric softener (if applicable)
-
into the corresponding compartments as described in figure 17.
Compartment 1: detergent powder
-
Compartment 2: liquid detergent (must not exceed the level marked MAX).
-
Compartment 3: additives such as softener (must not exceed the level marked MAX).
-
Observe the dosage recommendations of the detergent/softener manufacturer.
-
The correct dosage of detergent/softener is important because:
-
BOLERO DRESSCODE 10800 INVERTER A/ STEEL A
118