cecotec BOLERO DRESSCODE 9800 INVERTER A Manual De Instrucciones página 107

- Loosen 4 screws with a spanner and then remove them (A).
- Remove the 4 tube spacers (depending on model) (B).
- NOTE: during removal of the transport screws, occasionally the pipe spacers may fall
into the machine, if this happens, they can be accessed by tilting the machine forward
and picking them up from the floor or inside the base of the machine.
- Cover the transport screw holes with the 4 supplied plugs (C).
- Keep the transport screws properly for future use. You will need them again if the
washing machine needs to be moved to another location.
- If it is necessary to transport it to another location:
1. Reinstall the transport screws.
2. Secure the power cable to the rear of the appliance.
Levelling the washing machine
The appliance reaches high spin speeds to remove water at the end of the wash cycle.
Therefore, it is important that it is level and that all 4 legs press against the floor with the
same pressure.
This will help to ensure quieter operation and less vibration.
Carry out the following steps:
- Install the appliance on a solid, level surface. Preferably in a corner of the room.
- If the floor is uneven, adjust the legs as necessary to level the device. Do not place any
objects under the legs in an attempt to level it.
- Do not extend the legs more than necessary. The more extended, the more vibrations
the device will suffer. Start with the legs all the way in and adjust each one as
necessary.
- You can use a spirit level (not included) to check that the appliance is level.
- Press down on each corner of the top of the equipment to ensure that it does not
"wobble".
- All legs must press equally against the floor.
- When the device is level and does not wobble, lock the legs by tightening the lock nuts
against the bottom of the equipment. Be sure to do this without changing the height of
the leg (hold the leg while tightening the lock nut). Fig. 5
BOLERO DRESSCODE 9800 INVERTER A/ STEEL
ENGLISH
107