cecotec BOLERO DRESSCODE 9800 INVERTER A Manual De Instrucciones página 128

ENGLISH
6. TROUBLESHOOTING
Problem
There are coloured stains and
oil stains on the drum.
Bad smells
The door cannot be opened
Water spillage from
detergent dispenser
Water leaks
Does not turn on
128 BOLERO DRESSCODE 9800 INVERTER A/ STEEL
Possible cause and solution
The appliance requires a service wash. Run a "DRUM CLEAN"
wash cycle without detergent and laundry.
Due to the use of rubber parts, the machine will have a
rubber smell at the beginning of use, but the rubber smell will
gradually disappear during use.
Leave the door ajar after each wash cycle.
The safety protection function is in operation and the water
temperature and/or water level are too high.
If the programme has finished normally, but there is a power
failure.
Is the "CHILD LOCK" function activated? Deactivate the child
lock function.
Turn off the delayed end function.
The dispenser is blocked with detergent and requires cleaning.
The water pressure is too high and needs to be lowered; close
the tap on the water supply pipe slightly and try again.
The appliance is tilted forward - It must be level when in its
final position.
Water supply hose is loose, check connections.
Water supply hose is tight but still leaks; if so, replace the
rubber washers, or the water supply hose does not have the
rubber washer.
The drain hose is not positioned correctly.
In case of water leakage inside the machine, turn off the
power supply and contact Cecotec Technical Support.
Appliance is not fully plugged in or not plugged in enough to
make contact.
No power is reaching the socket. Check the fuses and control
and protection elements of the electrical installation.