cecotec BOLERO DRESSCODE 9800 INVERTER A Manual De Instrucciones página 109

2) To the sink trap
Secure the drain hose to the sink trap using a 0.9-1.6 inch (20-44 mm) hose clamp. Not
included. Available in hardware or specialised shops. Fig. 10
3) To a sink/washbasin
WARNING: DANGER OF BURNS
When washing at high temperatures, there is a risk of burns when touching hot soapy
water, e.g. when draining hot water with foam into the sink/washbin. Do not touch hot
soapy water.
Note:
Damage to the appliance / damage to textiles.
If the end of the drain hose touches the water drained by the washing machine, water can
be sucked back into the washer and damage the appliance or the laundry inside the drum.
To ensure that this does not happen, make sure that:
- No plug in the sink/washbasin drains.
- The end of the drain hose does not touch the drained water.
- Water flows freely through the sink/washbasin drain and there are no blockages.
- The hose is securely connected.
Note:
- Do not twist, pull or bend the drain hose.
- Fix the hose with a hose clamp to the drainpipe, sink/washbasin, etc., so that the hose
will not be forced out by the force of the water.
- For added safety, you can also use a drain hose holder (not included) and install the
hose over a sink/washbasin or tank, as shown in Figure 11.
- The use of hose extensions is not recommended; if absolutely necessary, the
extension should have the same diameter as the original hose and should not exceed
250 cm in length (Fig. 12).
- If drain hose is too long, do not force it into washing machine as it will cause abnormal
noises.
- After installation, wait a few hours before operating the appliance to allow it to
acclimatise to the ambient conditions in the room.
- Only connect the device when the installation has been completed.
BOLERO DRESSCODE 9800 INVERTER A/ STEEL
ENGLISH
109