cecotec BOLERO DRESSCODE 9800 INVERTER A Manual De Instrucciones página 108

ENGLISH
Connection of the supplied hoses
Water supply hose connection
1. Connect one end of the water supply hose to a cold water tap and tighten by hand (Fig.
6). Before making the connection, allow the water to run freely until it runs completely
clear.
2. Connect the other end of the water supply hose to the water inlet valve at the rear by
turning clockwise (Fig. 7).
3. Open the tap slowly and make sure there are no water leaks.
Warning
- Do not kink, crush, modify or sever the water inlet hose.
- Squeeze the end of the hose firmly by hand.
- The water supply pressure must be within a range between 0.03 and 1 MPa. If
the pressure exceeds this value, a pressure reducing valve (not included) must be
installed.
- If the hose is not long enough, please contact a specialised retailer, an authorised
technician or the Cecotec Service Centre.
- Never use a second-hand or used hose. Always use the hose supplied with the
equipment.
Drain hose connection
Drainage point height (Fig. 8)
Height difference between the floor and the drain:
- Minimum 60 cm (24 inches)
- Maximum 100 cm (39 inches)
Drainage connection types:
1) To the vertical drainage pipe
Connect the drain hose to the elbow (not included) of the drain pipe. Place the elbow on the
hose 4 inches (100 mm) from the end of the hose. Insert this section of hose into the pipe.
If the hose is pushed down too far, it can cause the washing machine to self-siphon, i.e.
to continuously empty as it fills with water. Secure the elbow and hose with a hose clamp
(not included) to prevent the hose from slipping out of the tube during use.
Fig. 9
1. Drainage pipe
2. Cold water
108 BOLERO DRESSCODE 9800 INVERTER A/ STEEL