cecotec BOLERO DRESSCODE 9800 INVERTER A Manual De Instrucciones página 126

ENGLISH
- Remove any coins, buttons and other objects from the seal after each wash.
Equipment decalcification
- As long as you use the correct amounts of detergent with the wash loads, descaling
is not necessary. If it is necessary to descale the drum of the appliance, follow the
instructions of the manufacturer of the descaling product.
- Small amounts of descaling agent can be used to remove white stains on the washing
machine drum caused by limescale or mineral deposits or small amounts of rust caused
by metal objects left in the drum.
NOTE: Descaling agents contain acids which can attack parts of the appliance and discolour
the laundry.
Checking the water supply hose
Check the water supply hose at least once a year. If there are cracks, it should be replaced
immediately, during the wash cycle, the water pressure is very strong, and a cracked water
supply hose could easily open.
Cleaning the detergent dispenser tank
If there is a build-up of residual detergent or additives, or if the softener compartment is
not rinsed well enough, the dispenser must be cleaned to avoid water overflows due to
blockages. Fig. 18
1. Open the detergent dispenser. Press down the tab (1) and pull the dispenser (2)
completely out of the washing-machine housing.
2. Remove the liquid detergent cap (3) by holding it and pulling it upwards from the
detergent dispenser.
3. Clean the lid and the dispenser itself under running water. Lightly wipe off any remaining
detergent residue.
4. Replace the cap and reinsert the dispenser back into place.
Tip: do not operate the appliance without the detergent dispenser in place. If the appliance is
not in use, always keep the dispenser closed.
Warning
Do not use alcohol, solvents or chemical products.
You can use a soft brush to remove detergent residues adhering to the dispenser.
Cleaning the mesh filter in the water supply hose and the water inlet valve
126 BOLERO DRESSCODE 9800 INVERTER A/ STEEL