cecotec BOLERO DRESSCODE 9800 INVERTER A Manual De Instrucciones página 130

ENGLISH
The high-speed spin must
be repeated many times
(spinning).
Machine does not spin
The machine vibrates a lot
during the spin cycle
Spinning result is not optimal
Machine does not drain,
drains slowly or "E03"
appears on the display.
The wash programme
time stops counting before
entering the high-speed spin
process.
Washing programme lasts
too long
130 BOLERO DRESSCODE 9800 INVERTER A/ STEEL
Due to different types and materials of laundry, the load
balancing system of the appliance may wobble and scatter
the laundry many times to extend the spin time. This is a
normal phenomenon, not an incidence of the machine.
No spin speed has been selected. The control panel displays
"—"
The legs have not been adjusted, causing the machine to rock.
New installation: the transport screws, including the plastic
spacer, or the polystyrene packaging, has not been removed
when installing the machine.
The appliance is trapped between furniture and/or walls.
The load is slightly unbalanced, and the device is rotating, but
at a slower speed.
When you wash less laundry, such as a pair of jeans, a jumper,
a bath towel, etc., the machine may not complete the spin
process due to balance protection.
If the load is slightly unbalanced, the appliance will spin, but at
a lower speed, not at the cycle's default spin speed or the spin
speed setting for the cycle.
The top of the drain hose is too high. It should be installed at a
height of 65-100 cm from the ground.
The draining pump filter is blocked.
Drain hose is kinked or bent.
Drain hose is blocked or frozen.
This is not an issue. The load balancing system of the
appliance tumbles and scatters the laundry in the drum
for a long time to achieve balance and complete the high
speed spin. In the process of tumbling and scattering, the
programme time stops counting before the appliance reaches
the high-speed spin process.
Programme times will vary due to water pressure, incoming
water, temperature, etc.
If the wash load becomes unbalanced, the time will increase.