cecotec BOLERO DRESSCODE 9800 INVERTER A Manual De Instrucciones página 125

first turn the wash cycle selector to select the "SPIN" programme, then turn off the "SPIN"
option by pressing the "SPEED" button to set the spin speed to "-" (should be displayed on
the digital display).
- Press the START/PAUSE button
drum during the wash cycle. The door unlocks at the end of the programme.
11. Switching off the device after the end of a wash programme
- At the end of the cycle, the message "END" is shown on the digital display.
- The door can only be opened when the DOOR LOCK
- Check that the DOOR LOCK indicator light is off, then open the door and remove the
laundry.
- Turn the wash cycle selector to switch off the machine to the "OFF" position.
- Leave the door ajar to allow the inside of the drum to dry out and prevent odours and
mould growth.
5. CLEANING AND MAINTENANCE
Warning
Before cleaning or maintaining, unplug the appliance and close the tap.
- Proper maintenance on the washing machine can extend its working life. The surface
can be cleaned with diluted non-abrasive neutral detergents when necessary. If there
is any water overflow, use a cloth to wipe it off immediately.
- Do not use abrasive cleaners or scouring pads to clean the device.
- Do not use pressurised water to clean the equipment.
Cleaning the drum
- The rusts left inside the drum by the metal articles shall be removed immediately with
chlorine-free detergents.
- Do not use steel wool.
Note
Do not put laundry in the washing machine during the drum cleaning.
Cleaning the door seals and glass
- Wipe the glass and seal after each wash to remove lint and stains. If lint builds up it
can cause leaks.
to run the SPIN programme. Water will drain from the
BOLERO DRESSCODE 9800 INVERTER A/ STEEL
indicator light goes out.
ENGLISH
125