Publicidad
Idiomas disponibles
Idiomas disponibles
2 Safety
2 Safety
This chapter describes the essential safety requirements and warns of residual hazards that should be kept
in mind, to kept the product safely. Non-observance of the safety instructions may result in risks to the life
and health of personnel as well as cause environmental or material damage.
2.1 Designated use
The device described in these operating instructions may be used only for the purpose and in the manner
described in these operating instructions. The WH Tandem alignment jig must be used to check and readjust
the torch neck geometry outside the welding cell. Unauthorized modifications or changes to enhance the
performance are not permitted.
► Do not make any structural modifications to the product.
► During welding work outdoors, use suitable protection against the weather conditions.
2.2 Responsibilities of the user
► Ensure that only suitably qualified personnel perform work on the device or system.
Suitably qualified personnel are:
— those who are familiar with the basic regulations on occupational safety and accident prevention;
— those who have been instructed on how to handle the device;
— those who have read and understood these operating instructions;
— those who have been trained accordingly;
— those who are able to recognize possible risks because of their special training, knowledge,
and experience.
► Keep non-suitably qualified people out of the work area.
EN - 4
WH Tandem alignment jig
Publicidad
