Publicidad
Idiomas disponibles
Idiomas disponibles
WH Tandem alignment jig
4 Product description
4.1 Structure and function
Fig. 1
Structure and function
A Torch seat
B Terminal block
C Gas nozzle holder
D Straightening unit
E Gaging sleeve
A
I
H
The torch neck (H) to be tested is clamped and fixed in the torch seat (A) and the terminal block (B).
The position of the torch neck (H) (bending angle) is checked with the help of the guided test sleeve (G).
The alignment lever (I) can be placed on the gas nozzle holder (C) and the torch neck (H) can be slightly
readjusted. The angle of the two torch necks (H) to each other is checked with the help of the
swiveling gaging sleeve (E). The straightening unit can be modified to fit the torch type. The holes in the
base plate (F) are marked with the torch numbers and indicate the corresponding positions.
4.2 Technical data
Tab. 1
General information
Weight
Dimensions (L × W × H)
Tab. 2
Ambient conditions, transport, storage and operation
Ambient temperature
(operation, storage in a closed environment)
Ambient temperature (transport)
Relative humidity
F Base plate
G Test sleeve
H Torch neck
I Alignment lever
B
4 Product description
C
D
E
G
F
17 kg
650 mm × 250 mm × 180 mm
−25°C to +55°C
−25°C to +55°C
Up to 90% at +20°C
EN - 7
Publicidad
