Publicidad
Idiomas disponibles
Idiomas disponibles
WH Tandem alignment jig
11 Disposal
11 Disposal
When disposing of the system, local regulations, laws, provisions, standards and guidelines must be
observed. For the WH Tandem alignment jig to be properly disposed of, it first must be disassembled.
See 10 Disassembly on page EN-12.
11.1 Disposal of materials
This product is mainly made of metallic materials that can be melted in steel and iron works and are thus
almost infinitely recyclable. The plastic materials used are labeled in preparation for their sorting and
separation for later recycling.
11.2 Disposal of consumables
Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system. These
substances must be stored, transported and disposed of in suitable containers. Contaminated cleaning tools
(brushes, rags, etc.) must also be disposed of in accordance with the information provided by the
consumables' manufacturer.
► Please observe the relevant local regulations and disposal instructions in the safety data sheets
specified by the manufacturer of the consumables.
11.3 Packaging
ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle
packaging materials is always considered during their selection.
12 Warranty
This product is an original ABICOR BINZEL product. Alexander Binzel Schweisstechnik GmbH & Co. KG
guarantees that the product has been manufactured without defects and offers factory manufacturing and
functional warranty for this product upon delivery in line with current state-of-the-art technology and the
current regulations. If ABICOR BINZEL is responsible for a defect that is present, ABICOR BINZEL is obliged
to remedy the defect or deliver a replacement at its own cost and its own discretion. The warranty covers
manufacturing faults, but not damage resulting from natural wear and tear, overloading or improper use.
The warranty period is defined in the General Terms and Conditions. Exceptions in the case of specific
products are regulated separately. Warranty will also be rendered invalid if spare and wear parts are used
that are not original ABICOR BINZEL parts and if the product has been repaired improperly by the user or
a third party.
Wear parts are excluded in general from the warranty. In addition, ABICOR BINZEL is not liable for
damage caused by using our products. Questions about warranty and service can be addressed to the
manufacturer or our distributors. For more information, visit www.binzel-abicor.com.
EN - 13
Publicidad
