Abicor Binzel WH Tandem Manual De Instrucciones Original página 24

7 Operation
7 Operation
7.1 Mounting the torch neck in the WH Tandem alignment jig
Fig. 4 Mounting the torch neck in the WH Tandem alignment jig
A Liner
B Torch neck
C Gas nozzle holder
D Contact tip
E Gas nozzle
F Straightening unit
A
Q
P
O
N M
Loosen and remove the gas nozzle (E) with the hoses.
1
Unscrew and remove the contact tip (D) and liner (A).
2
Loosen the clamp lever (O) and pull out the hexagon bolt (Q).
3
Insert the torch neck (B) into the torch seat (N) so that the support cone is flush with the torch seat (N)
4
and the locking clamp is in contact with the terminal block (M).
Fasten the torch neck (B) to the torch seat (N) with knurled screws (P).
5
EN - 10
G Base plate
H Gaging sleeve
I Index plate
J Tilting lever
K Tip adaptor
L Test sleeve
B
L
WH Tandem alignment jig
M Terminal block
N Torch seat
O Clamp lever
P Knurled screw
Q Hexagon bolt
C
D
K J I H
E
F
G