Oase Bitron Premium 60 W Instrucciones De Uso página 49

Attachment to the filter system ProfiClear Premium XL pumped
The UVC clarifier is attached to an inlet DN 110 of the ProfiClear Premium TF-XL pumped.
• If the pump is installed at a dry location, the pressure-side and suction-side connection thread
must be sealed with Teflon tape.
Fitting the UVC clarifier
How to proceed:
1. Open the hose clip of the rubber sleeve and push the rubber sleeve onto the UVC clarifier out-
let.
– Required assembly materials: OASE accessories 73751 (rubber sleeve).
2. Position the UVC clarifier in front of the inlet DN 110 of the drum filter and connect the outlet
to the inlet of the drum filter using the rubber sleeve. Tighten the hose clips of the rubber
sleeve.
3. Screw the triangular plate to the UVC clarifier.
– The UVC clarifier is fastened to the container using the triangular plate.
– The triangle plate is supplied with the drum filter.
4. Connect the outlet of the pump with the inlet of the UVC clarifier.
– Required assembly materials: OASE accessories 77191, 73751 and hose ∅ 50 mm.
5. Fasten the switch box on the UVC clarifier. (→ Installing the switch box)
EN
BTN0067
49