To connect the appliance to a different Wi-Fi network, even if the one in use needs to
be changed (e.g. change of provider), or if a connection attempt is unsuccessful:
Remove the device from the app.
Proceed to reset the connection by tapping the E icon for five seconds. The D
icon will start flashing.
Re-connect to the new network as described above.
5.
COMMISSIONING AND FIRST START-UP
Some preliminary operations are necessary before first use. Proceed as follows:
Unpack the appliance and check the conditions and completeness of the equipment,
as indicated in the previous chapter.
Keep the packaging for 15 days in case it needs to be returned to the retailer; after this
period, dispose of it in accordance with the instructions on the separation of materials
indicated on it.
Read this manual in its entirety, paying particular attention to the instructions for safe
use.
Carefully remove all possible fastening materials from parts, including internal parts.
Fully remove any stickers from the surface of the appliance.
Place the appliance on a flat, stable surface, taking care to reserve 10 cm of space on
all sides, at the rear and above the appliance for the necessary air circulation.
Refer to chapter 2 for further details and instructions on appliance positioning and
installation.
Wash all accessories in lukewarm water with normal dish soap. Rinse properly and wait
until completely dry before proceeding further.
Connect the electrical plug to a wall socket with a regular upstream earth leakage
circuit breaker.
Ensure that the cord does not come into contact with hot parts and that it is not
subjected to excessive bending or kinking.
Tap the S icon to turn on the device.
Tap the P icon, then the L icon repeatedly until 3 minutes are set.
Tap the N icon, then the R icon repeatedly until 200° C is set.
Start the program by tapping the S icon.
At the end of the program, remove the drawer, check the general conditions of the
appliance and wait for it to cool down. You can now carry out the normal cooking
operations.
26