Publicidad
Idiomas disponibles
Idiomas disponibles
6.
USING THE APPLIANCE
Cooking involves placing the food inside the drawer and inserting it completely into the
compartment until it clicks into place, before any operation on the control panel. It is
possible, and in some cases at least advisable if the nature of the food requires it,
preheat the cooking chamber, as described in the following chapter "Preheating". At the
end of cooking, the appliance stops all heating, emits a few prolonged beeps and, after
a brief cool down, goes into standby. At this point, the drawer can be pulled out and the
food inside can be removed and consumed, while the appliance can be left to cool down,
preferably with the drawer pulled out, for subsequent cleaning.
After even a short period of inactivity, even if connected to the electrical outlet, the
appliance is completely switched off, with the exception of the S icon. To switch to stand-
by mode, tap the S icon. The push-button panel lights up and the display shows the pre-
set temperature of 180° C and the pre-set cooking time of 15 minutes, alternately. It is
now necessary to program the cooking parameters and start the process.
You can select one of the 8 pre-set programs to cook the most common foods according
to specific factory parameters for each type of food or else opt for a free cooking
program with which you can set the cooking temperature and duration of the process
according to your own experience or needs.
Remove the drawer from the compartment, then place the food inside, taking care to:
Make sure that the grease trap grille is in place at the bottom of the container This
allows for healthier and more uniform cooking and prevents the formation of fumes and
unpleasant odours.
Avoid overloading the container too high to prevent contact with the heating element.
Arrange the food on as much of the surface of the container as possible to prevent
accumulation and uneven cooking.
Push the drawer all the way back in until it clicks into place.
PRE-SET PROGRAMS
After carrying out the above, to start one of the 8 pre-set programs, tap the K icon
repeatedly: the icons of the different pre-set programs will flash sequentially, indicating
the program currently selected by its flashing. If you wish to customise the pre-set
program, limited to the preparation in progress, it is possible at this time to modify the
pre-set programs both in terms of temperature by tapping the N icon and in duration by
tapping the P icon. The values can be modified by tapping the L and R icons. To start
cooking, tap the S icon.
You can select a pre-set program from the following:
27
Publicidad
