Shark AERON-GP Manual Del Usuario página 11

INTERIOR DISASSEMBLY
5 & 6 - Completely remove the cheekpiece
by sliding it onto the end of its chin strap
fastener while turning the helmet over if
necessary.
6 - Repeat the procedure to remove the
left cheekpiece.
7 - Unsnap the two snaps on the rear of
the liner. Slide your hand under the back
of the liner and pull towards you on either
side to release the liner from its two snap-
fastening housings.
8 - Unclip the front part of the liner, clip by
clip, by pulling inwards and starting from
one end of your choice. Once the liner is
completely undone, it can be removed.
CAUTION! The positioning of
the interior is critical for keeping the
helmet on your head. If you are unsure
about disassembling or reassembling the
interior, do not use your helmet. Contact
your retailer for assistance and advice.
Never use a helmet missing any part
making up its interior, it will not protect
you in the event of an accident.
CAUTION! The shell and inner
liner are made to fit perfectly on your
head. In the event of an accident, a
helmet that does not fit you may come
off, leaving your head unprotected and
causing serious or even fatal injuries.
If you are not sure that the interior has
been reassembled correctly, do not use
your helmet. Contact your retailer for
assistance and advice.
6
7
8
11