Publicidad
Idiomas disponibles
Idiomas disponibles
en
16
Changing the tool.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acci-
dental starting of the power tool.
The symptom for worn punches and dies
are a clearly increased feed force at lower
working progress.
The punch – not the die – can be reground
as long as the length of the reground punch
does not fall below the minimum die length.
Die
BLK3.5E (**):
3 13 09 093 00 3
3 13 09 094 00 1
Minimum punch
length
2.0276 in
51.5 mm
2.0276 in
51.5 mm
Die
BLK5.0E (**):
3 13 09 109 00 2
3 13 09 107 00 0
3 13 09 108 00 8
BLK3.5E (**): For template cuts, the template
is traced via the lower cylindrical part of the
punch guide. The clearance between tem-
plate and the actual cutting edge is 0.0984 in
(2.5 mm).
The template should be at least 0.0787 in
(2 mm) thick; the total thickness of template
and work piece may not exceed 0.2165 in
(5.5 mm).
Minimum punch
length
2.3150 in
58.8 mm
2.2283 in
56.6 mm
2.1457 in
54.5 mm
Publicidad
