GLOBBER E-MOTION 11 Manual Del Propietário página 7

3 - ASSEMBLY
UNFOLD THE SCOOTER
1. Prior to inserting the steering column into the threaded axle, safely plug the accelerator throttle cable.
- Insert the steering column into the threaded axle; do not tighten the clamp at this stage.
- Caution: Make sure the accelerator cable is not pinched and is firmly plugged when inserting the steering column into the
threaded axle.
2. Place the handlebar in the housing at the top of the steering column and secure the clamp with the two screws.
3. Align the handlebars with the wheel axle; then, tighten the clamp at the bottom of the threaded axle. The required clamping/
tightening force is between 5 to 7 N/m.
1
MOUNTING FRONT LIGHT & BELL:
Take the LED light out from the paper box; then, install the LED light to the top part of the
handlebars; place it on the left-hand side with the light facing forward. Fix it tightly with the
plastic hook.
To fix the bell on the handlebars, loosen the screw to open the loop and mount the bell on
the right-hand side of the handlebars. Tighten the screw to fix its position.
4 - MODE OF OPERATION AND USE
ON/OFF FUNCTION
- To start the scooter, press once the ON/OFF button located at the top of the handlebars. Always remember to press the ON/OFF
button to start the scooter.
- When the taillight lights up in red, the scooter is in "ON" mode. The LED battery gauge and LED side lights will light up too. The
deck is equipped with LED lights on both sides.
- To turn off the scooter, press and hold the ON/OFF button until the taillights turn off; release the ON/OFF button and the LED
battery gauge lights and the LED side lights will also turn off.
- Your E-MOTION 11/E-MOTION 160 will automatically turn off after 10 minutes of inactivity; the battery lights' signal on the deck
will also turn off.
START-UP
Once the scooter is in "ON" mode, it is now ready to start. Two actions are necessary to engage the motor:
- Press the acceleration throttle located at the right side of the handlebar to start and accelerate. Kick start to activate the motor.
Push your scooter to reach a speed of 3km/h.
- Be aware that once the motor is turned ON, reducing your speed below 3km/h does not automatically turn off the motor; read the
"STOP" paragraph section for instructions on how to turn off the motor.
HOW TO RIDE THE SCOOTER
- Make sure the scooter is in "ON" mode.
- Place your feet on the deck.
- Push the scooter with your foot until you reach a speed of 3km/h to engage the electric motor.
- Press the throttle accelerator located at the right side of the handlebar to start and accelerate.
- The maximum speed is 15km/h in speed mode 2 and 6km/h in speed mode 1.
- To slow down, you can simultaneously or independently activate both:
The rear foot brake by pressing with your rear foot.
Release the throttle accelerator while keeping both hands on the handlebars.
- Important: The taillight has a brake function. Each action of the rear foot brake will engage the brake light, and the taillight will
then light up brighter to indicate the braking.
2 3
ENGLISH
7