GLOBBER E-MOTION 11 Manual Del Propietário página 8

STOP
- To stop, keep pressing the rear brake continuously for 3 seconds and wait for the scooter to stop safely to alight the scooter.
- The action of the foot brake will simultaneously engage the electromagnetic motor brake, the mechanical brake, and the brake
light.
- At any time, you can remove your finger from the throttle accelerator to automatically shut down the motor, for example in an
emergency. The battery will automatically turn itself off when the motor is not engaged for more than 10 minutes.
SPEED MODE SELECTION
When you first press the ON/OFF button, the scooter is by default in speed mode 2. When the scooter is "ON", but the motor is not
engaged, the scooter is in standby mode.
In standby mode, you can switch between the 2 speed modes by double-clicking the ON/OFF button.
- Speed mode 1: max speed is 6km/h, and the taillight, battery gauge, and side LED lights will flash.
- Speed mode 2: max speed is 15 km/h, and the taillight and battery gauge will light up continuously while the side LED lights
will flash slowly.
To switch from speed mode 2 to speed mode 1, double-click the ON/OFF button. The taillight will start flashing in red. The battery
gauge and the LED lights on both sides of the deck will also flash, showing that the scooter is now in speed mode 1. The max
speed in this mode is 6km/h.
To switch back to speed mode 2 from speed mode 1, double-click the ON/OFF button again. The taillight will stop flashing in red
and stay on. The battery gauge will stay on and the LED lights on both sides of the deck will flash slowly, showing that the scooter is
now back in speed mode 2 . The max speed in this mode is 15km/h.
5 - CHARGING
When the battery signal light on the deck becomes low, you can recharge the battery with the specific charger included in pack.
IMPORTANT:
The battery has temperature protection. If you try to charge the scooter just after riding, the battery pack might be at a high
temperature, and it will not accept charging until about 25 minutes after the battery pack cools down.
Warning for battery charging: Use only the charging device provided with your scooter
(model ref. FY0422401200 E)
Your electric scooter is delivered with a specific charger. Only charge the scooter indoors and with this specific charger. The external
flexible cable of this charger cannot be replaced; in case of damage, the charger must be recycled.
1. To charge your electric scooter, make sure the electric scooter is in "OFF" mode by switching OFF; then, remove the waterproof
cap from the port and plug in the charger. For safety reasons, ensure the charging port is always dry before starting to charge.
2. Plug the charger into a suitable power source.
3. When the LED on the charger is red, the battery is charging.
4. When the LED light changes to green, the battery is fully charged; this will take approximately 4 hours. You must stop charging it
when the signal light turns green; charging the battery for too long will reduce its lifetime.
The protective cover is used to protect the charging port from splashing water. Be sure to replace the cap after each charging and
before each use.
- Children shall not play with the appliance.
- Cleaning and user maintenance should not be done by children without supervision.
- Warning: The charger (model ref. FY0422401200E) is specific for lithium battery pack 21.6V and 4.0Ah
( Model No.: 6S2PSCOOTERM20).
ENGLISH
8