cecotec BOLERO GRANDSOMMELIER 1230 COOLCRYSTAL Manual De Instrucciones página 50

ENGLISH
1. At least 200 cm3 must be left free around the device.
2. The distance between the wall and the back of the wine cooler must be at least 20 mm.
3. The lateral distance between other objects or furniture must be at least 50 mm.
4. Air circulation around the wine cooler must be ensured at all times.
Place the appliance on a solid, flat surface to keep it stable, or vibrations and noises will
-
occur. Make sure that the appliance is level by adjusting the height with its legs. If possible,
do not place it directly on the ground.
Wait at least 2-3 hours before plugging it into a power outlet and inserting the bottles.
-
Clean the inside with a soft cloth and lukewarm water. Check that the shelves are correctly
positioned.
Installation is recommended in a location with an ambient temperature between 16ºC and
-
32ºC. A lower or higher temperature than indicated, may affect the optimal functioning of
the equipment.
It is not advisable for the wine cooler to remain in operation if the temperature is below
-
10ºC.
- You can have a container with water inside the appliance to maintain humidity levels.
4. OPERATION
This appliance has a temperature control on the front. You can adjust the temperature between
8-18 °C (46-64 ºF). The internal temperature could be affected by factors such as the location
of the appliance, the ambient temperature and the frequency with which the door is opened,
etc.
Control panel. Fig. 2
Unlock button
1.
2. Temperature/light control button
3. Temperature indicator
Temperature increase button
4.
5. Temperature decrease button
Switch-on
Plug in the appliance. Set the desired temperature using the temperature increase or decrease
buttons.
Please note
After setting the temperature, the temperature display will show the internal temperature of
the appliance, which will gradually change until the set temperature is reached.
50
BOLERO GRANDSOMMELIER 1230 COOLCRYSTAL / COOLWOOD