Fronius TTG 1600 S Manual De Instrucciones página 18

General
General remarks The TIG gas valve welding torch (S) and the TIG welding torch with potentiome-
ter (Pot) are available in many versions and are suitable for welding CrNi and
steel.
The welding torches can be used in an extremely wide range of applications. They
are ideally suited for manual series production and one-off jobs, such as in work-
shops.
Safety
Work that is not carried out correctly can cause serious injury and damage.
The actions described herein may ONLY be carried out by skilled, trained techni-
cians! Observe the instructions given in the attached document "Safety rules".
An electric shock can be fatal.
Only carry out the actions described here if:
▶
▶
An electric shock can be fatal.
Before cleaning the welding torch and inspecting its components, shift the mains
switch of the power source into the - O - position.
The torch becomes extremely hot during welding - risk of burns! Cleaning of the
welding torch, and inspection of its components, may only be carried out once
the torch has cooled down.
Risk of injury from inadequate connections.
All cables, leads and hosepacks must be firmly attached, undamaged, properly
insulated and adequately.
18
WARNING!
WARNING!
the mains switch of the power source is in the - O - position, and
the power source has been disconnected from the mains.
WARNING!
CAUTION!
CAUTION!