Fronius Robacta Drive Manual De Instrucciones página 48

Fitting the
1
mounting bra-
cket (individual-
ly)
3
IMPORTANT! Drill a Ø5.8 mm hole for the mounting bracket and use a reamer to
enlarge the hole so it can accommodate the dowel pin (Ø6G7).
IMPORTANT! The mounting bracket must be fitted using an M8 shoulder screw.
The required bracket must then be positioned and two dowel pins (Ø6 mm) dri-
ven in to secure it.
Robacta torch
necks - dismant-
ling and assemb-
Risk of coolant escaping through loose union nut.
ling
This can result in serious injury and damage to property.
▶
▶
48
CAUTION!
When fitting the torch neck, ensure that the union nut is securely fastened:
Tighten union nut using a flat spanner.
For a defined, reproducible tightening torque, use a flat spanner and torque
wrench, ideal tightening torque = 18 ±2 Nm.
2
Reibahle /
Reamer /
Alésoir /
Alesatore /
Escariador /
Alargador
Ø6G7
Bohrer /
Drill /
Foret /
Punta del
trapano /
Broca /
Broca
Ø5,8