Fronius Robacta Drive CMT W Manual De Instrucciones página 61

Every start-up -
-
-
-
-
-
* Check spatter guard and insulation for damage
Check the contact tube
Replace worn out contact tube
Remove welding spatter from gas nozzle (e.g. manually, by blowing off, or by
using a Robacta Reamer or Robacta TC 1000)
If there is dirt that cannot be removed from around the nozzle join, replace
the gas nozzle
Check the water connections for leaks
Monitor the water return level in the coolant container and vent the cooling
unit if necessary
2
1
61