Publicidad
Idiomas disponibles
Idiomas disponibles
English
(11) Next, depress the Push Lever against the workpiece.
Now pull the Trigger.
□ THE NAILER MUST OPERATE.
(12) If no abnormal operation is observed, you may load
nails in the Nailer.
Drive nails into the workpiece that is the same type to
be used in the actual application.
□ THE NAILER MUST OPERATE PROPERLY.
ADJUSTING AIR PRESSURE
Adjust the air pressure at recommended operating
pressure 70–120 psi (4.9–8.3 bar 5–8.5 kgf/cm
according to the length of nails and the hardness of
workpiece.
The correct air pressure is the lowest pressure which will
do the job. Using the Nailer at a higher than required air
pressure unnecessarily over stresses the Nailer.
LOADING NAILS
● When loading nails into Nailer,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
(1) Grip the nail guide and knob with fi nger.
Press the knob down and swing the nail guide open.
And open the magazine cover.
Knob
Nail guide
14
WARNING
● Do not exceed
120 psi (8.3 bar
8.5 kgf/cm
WARNING
Magazine cover
(2) Adjust the position of the plate according to the nail
length.
The nail will not feed smoothly if the plate is not
correctly adjusted.
Magazine
NOTE: Before loading nails in the magazine, adjust
).
2
the plate. If the magazine cover is forcibly
closed without adjusting the plate correctly,
the nail holder may be damaged.
Turn the nail holder about 90 degrees
counterclockwise.
)
2
Slide in vertical direction possible.
Lift or lower the nail holder to accept diff erent
length nails.
Adjust the plate to the nail length reference points
on the magazine cover and turn the nail holder 90
degrees clockwise until you hear "click".
2"
1
3
2
/
" 2
/
4
8
1
3
2
/
" 2
/
"
2
4
1
3" 3
/
"
4
Magazine
(3) Place the nail coil into the magazine.
Uncoil enough nails to reach the driving hole.
Magazine cover
Nail holder
"
Magazine cover
Nail holder
Nail holder
Nails
Magazine
Publicidad
