Publicidad
Idiomas disponibles
Idiomas disponibles
6. WARNING LABEL
Do not use the Nailer with missing or damaged
WARNING LABEL.
A new WARNING LABEL is available from a
metabo HPT authorized service center.
7. Maintenance chart (See page 23)
8. Operator troubleshooting (See page 24)
CAUTION
● In the operation and maintenance of power tools,
the safety regulations and standards prescribed
in each country must be observed.
Maintenance chart
ACTION
Drain air line fi lter daily.
Keep lubricator fi lled.
Clean fi lter element and blow air
through fi lter in direction opposite to
normal fl ow daily.
Clean magazine and feeder
mechanism.
Keep push lever working properly.
Lubricate the Nailer after nailing.
Drain air compressor daily.
SERVICE AND REPAIRS
Warning
All quality Nailers will eventually require servicing or
Label
replacement of parts because of wear from normal use.
NOTE: Specifi cations are subject to change without any
WHY
Prevent accumulation of moisture
and dirt.
Keep the Nailer lubricated.
Prevent clogging of fi lter with dirt.
Prevent a jam.
Promote operator safety and effi cient
Nailer operation.
Extend the Nailer life.
Keep the Nailer operated properly.
WARNING
● Only
service
personnel
metabo HPT, distributor or employer
shall repair the Nailer.
● Use only parts supplied or recommended by
metabo HPT for repair.
obligation on the part of metabo HPT.
Open manual petcock.
Fill with metabo HPT pneumatic tool
lubricant.
Follow manufacturer's instructions.
Blow clean daily.
Blow clean daily.
Supply 5–10 drops of lubricant into
the Nailer.
Open petcock on air compressor
tank.
English
trained
by
HOW
23
Publicidad
