Publicidad
Idiomas disponibles
Idiomas disponibles
Shaft Ring
Body
(3) Inspection after assembly
Perform an after-assembly inspection according to
the procedure below.
Disconnect the air hose.
REMOVE ALL NAILS FROM NAILER.
□ THE PUSH LEVER AND TRIGGER MUST MOVE
SMOOTHLY.
Adjust air pressure to 70 psi (4.9 bar, 5 kgf/cm²).
Connect the air hose.
□ THE NAILER MUST NOT LEAK AIR.
NOTE: The information contained in this Manual is designed to assist you in the safe maintenance of the Nailer.
Some illustrations in this Manual may show details or attachments that diff er from those on your own Nailer.
MAINTENANCE AND INSPECTION
Read section titled "SAFETY" (pages 3–7).
● Disconnect air hose and remove all nails
from Nailer when:
1) doing maintenance and inspection; and
2) clearing a jam.
1. Clearing a jam
Remove a jammed nail in the following order:
DISCONNECT AIR HOSE.
Open the nail guide.
Insert a rod into the outlet.
Tap the rod with a hammer.
Trigger Pin
Trigger (A)
Fig. 4
MAINTENANCE
WARNING
Remove your fi nger from the trigger and press the
push lever against the workpiece.
□ THE NAILER MUST NOT OPERATE.
Separate the push lever from the workpiece. Next,
point the nailer downward, pull the trigger, and keep
that position for 5 seconds or longer.
□ THE NAILER MUST NOT OPERATE.
With the nailer off the wood, pull the Trigger. Next,
depress the Push Lever against the workpiece.
□ THE NAILER MUST OPERATE.
Next, depress the Push Lever against the workpiece.
Now pull the Trigger.
□ THE NAILER MUST OPERATE.
If no abnormal operation is observed, you may load
nails in the nailer.
Drive nails into the workpiece that are the same type
to be used in the actual application.
□ THE NAILER MUST OPERATE PROPERLY.
If a problem occurs during the inspection described
above, do not attempt to repair the nailer yourself;
please bring it to the nearest metabo HPT authorized
service center.
Hammer
Rod
Outlet
English
Disconnect
air hose
21
Publicidad
