Metabo HPT NV 83A5 Instrucciones Y Manual De Seguridad página 22

English
Remove the jammed nail with a slotted screw
driver.
Nail
Cut the deformed collated wire with nippers.
Correct the deformation.
In case of frequent jam, contact a metabo HPT
authorized service center.
2. Inspecting the push lever
DISCONNECT AIR HOSE.
Clean the push lever sliding part.
Lubricate it with metabo HPT pneumatic tool
lubricant.
Lubricate
3. Inspecting the feeders
DISCONNECT AIR HOSE.
Clean the knob sliding part.
Lubricate it with metabo HPT pneumatic tool
lubricant.
Nail
Guide
Push Lever
22
Slotted Screw Driver
Disconnect
air hose
Disconnect
Knob
air hose
Open the nail guide and remove dust.
Lubricate the sliding groove of the feeder and
shafts.
Nail Guide
Main Nail Stopper
Sub Nail Stopper
Lubricate the feeding surfaces of the nose and
the nail guide after cleaning.
This promotes smooth operation and prevents
rust.
CAUTION
● Check that the main nail stopper and sub nail
stopper slide smoothly by pushing them with
fi nger.
If not smooth, nails can be driven at an irregular
angle and hurt someone.
4. Inspecting the magazine
DISCONNECT AIR HOSE.
Clean the magazine. Remove dust or wooden tips
which may have accumulated in the magazine.
5. Storing
○ When not in use for an extended period, apply a
thin coat of the lubricant to the steel parts to avoid
rust.
○ Do not store the Nailer in a cold weather
environment.
Keep the Nailer in a warm area.
○ When not in use, the Nailer should be stored in a
warm and dry place.
Keep out of reach children.
Nose Opening
Feeder Shaft
Feeder