Publicidad
Idiomas disponibles
Idiomas disponibles
the user guide and make sure the
electric and water utilities are as
required. If the installation is not
suitable, call a qualified electrician
and plumber to have them make
the necessary arrangements.
Otherwise, electric shock, fire,
issues with the product or injuries
may occur.
Check for any damage on the
product before installing it. Do not
have the product installed if it is
damaged.
Place the product on a level and
hard surface and balance with
the adjustable legs. Otherwise,
the refrigerator may tip over and
cause injuries.
The product shall be installed in a
dry and ventilated environment.
Do not keep carpets, rugs or similar
floor covers under the product.
This may cause risk of fire as a
result of inadequate ventilation!
Do not block or cover ventilation
holes. Otherwise, power
consumption may be increased
and damage to your product may
occur.
Do not connect the product to
supply systems such as solar
power supplies. Otherwise,
damage to your product may occur
as a result of the abrupt voltage
fluctuations!
The more refrigerant a refrigerator
contains, the bigger its installation
room shall be. In very small rooms,
a flammable gas-air mixture may
occur in case of a gas leak in the
cooling system. At least 1 m3 of
volume is required for each 8
grams of refrigerant. The amount
of the refrigerant available in your
product is specified in the Type
Label.
The installation place of the
product shall not be exposed to
direct sunlight and it shall not be in
the vicinity of a heat source such
as stoves, radiators, etc.
If you cannot prevent installation of
the product in the vicinity of a heat
source, you shall use a suitable
insulation plate and the minimum
distance to the heat source shall
be as specified below.
- At least 30 cm away from
heat sources such as stoves, hea-
ting units and heaters, etc.,
- And at least 5 cm away from
electric ovens.
Your product has the protection
class of I. Plug the product in a
grounded socket that conforms
with the Voltage, Current and
Frequency values specified in the
type label. The socket outlet shall
be equipped with a fuse with a
rating of 10 A – 16 A. Our company
shall not be responsible for the
damages that shall be incurred as
a result of operating the product
without ensuring ground and
electrical connections made as per
local or national regulations.
The product's power cable must
be unplugged during installation.
Otherwise, risk of electric shock
and injury may occur!
Do not plug the product to loose,
broken, dirty, greasy sockets or
sockets that has come out their se-
ats or sockets with a risk of water
contact.
Place the power cord and hoses (if
available) of the product so that they
shall not cause a risk of tripping
over.
DK
Fİ
SV
NO
CZ
SK
RO
5
Publicidad
