Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Icemaker
Potable Water
Inlet G3/4
Inlet Hose
Drain Outlet R3/4
Outlet Hose
Fig. 22
8. START-UP PROCEDURE
Before starting the unit, energise the Oil Heater around the lower
part of the Compressor to prevent a starting failure caused by the
refrigerant staying inside the Compressor:
) Move the Washing Switch on the Control Box to the "WASH"
position.
2) Push the Bin Control Switch to the right into the
"bin full" position, and fix it there with tapes.
3) Connect the power supply.
4) After 0 seconds in the defrost cycle, the unit
stops. Leave the unit for 2 hours (Oil Heater
energised).
5) Open the water tap.
6) Move the Washing Switch
to the "ICE" position, and
r e l e a s e t h e B i n C o n t r o l
Switch into the initial "running"
position.
7) The following should occur in sequence:
a) Compressor will start (Hot Gas Valve open).
b) Water Pan will fully open.
c) Water Solenoid will open.
d) Water Pan will start to close (Hot Gas Valve closed).
e) Water Pan fully closed - Pump Motor will start.
f) Water Solenoid will close.
Water Supply Tap
Inlet Hose
Fig. 23
Washing
Switch
Control Box
Fig. 24
Fig. 25
Fig. 26
8) The unit will start a freeze cycle in 80 seconds.
. Check the conditions and quality of the ice production.
2. Do not use ice produced in the trial run. It might be
contaminated with foreign matter in the water circuit. Discard
or flush down the drain.
9. FINAL CHECKS
) Is installation free of water leaks?
2) Is the icemaker free from vibration?
3) Are all the panels fixed and secure?
4) Has the user been instructed on correct machine use and handed
the Instruction Manual?
6
IMPORTANT
Publicidad
