Stihl TS 500i Manual De Instrucciones página 37

Tensioning the Ribbed V-belt
This machine is equipped with an
automatic spring-action V-belt
tensioning device.
2
1
1
1
Prior to tensioning the ribbed V-belt, the
nuts (1) must be loosened and the arrow
on the tensioning nut (2) must point to 0.
otherwise loosen the nuts (1) and
N
the tensioning nut (2) with the
combination wrench
counterclockwise –
approx. 1/4 turn, as far as
possible = 0
1
1
1
to tighten the ribbed V-belt, fit the
N
combination wrench over the
tensioning nut as illustrated
WARNING
The tensioning nut is spring-loaded –
hold the combination wrench securely.
TS 480i, TS 500i
Turn the tensioning nut clockwise
N
approx. 1/8 turn – the tensioning nut
will be engaged by the spring
Continue turning approx. 1/8 turn –
N
up to the stop
NOTICE
Do not turn the combination wrench
further by force.
0
The V-belt is automatically tensioned by
the force of the spring in this position.
Remove the combination wrench
N
from the tensioning nut
Tighten up the nuts (1)
N
Retensioning the V-belt
The V-belt is retensioned without the aid
of the tensioning nut.
1
Loosen the nuts (1) – V-belt is
N
retensioned automatically by the
force of the spring
Tighten up the nuts (1) again
N
Mounting an Abrasive
Cutting Wheel
The engine must be shut off for
mounting or replacing a wheel – set the
stop switch to STOP or 0.
Blocking the shaft
1
1
Slide the locking pin (1) through the
N
bore hole (2) in the V-belt guard
Turn the shaft with the combination
N
wrench until the locking pin (1)
engages in the bore hole behind the
guard
English
2
1
35