Stihl TS 500i Manual De Instrucciones página 46

English
Installing the spark plug
Check the electrode gap of the
N
spark plug and adjust it as
necessary. See specifications
Install the spark plug by hand and
N
screw it in
Tighten the spark plug with an
N
appropriately sized combination
wrench
Press the spark plug boot firmly
N
onto the spark plug
Position the cap for the spark plug
N
boot and screw it down securely
44
Replacing the V-belt
2
1
1
1
Undo the nuts (1)
N
Turn the tensioning nut (2)
N
counterclockwise with the
combination wrench –
approx. 1/4 turn, as far as it will
go = 0
4
3
Pull the water hose out of the guide
N
in the V-belt guard
Loosen the screw (3)
N
Raise the V-belt guard (4) slightly
N
and pull it off to the front
0
1
Remove the V-belt from the front
N
pulley
Remove the nuts (1)
N
Remove the starter cover (5)
N
Do not remove the "cast arm and
N
guard" (6) – hold it in place on the
studs until the starter cover is fitted
back in position
Remove the old V-belt
N
8
Carefully insert the new V-belt (7)
N
on the V-belt pulley (8) on the
engine and the front V-belt
pulley (9)
NOTICE
The belt action must run smoothly.
6
1
5
1
9
7
TS 480i, TS 500i