Stihl TS 500i Manual De Instrucciones página 47

10
10
10
1
5
1 1
Fit the starter cover (5) over the
N
studs (10)
Tighten up the nuts (1) by hand
N
4
3
Push the V-belt guard (4) into place
N
Screw in the bolt (3) and tighten up
N
Insert the water hose into the guide
N
in the V-belt guard (arrows) from the
water connection towards the guard
– avoid tight radiuses
Continue as described in the chapter
"Tensioning the V-belt."
TS 480i, TS 500i
Cut-off Machine Cart
The cut-off machine can be mounted on
the STIHL cut-off machine cart FW 20
(special accessory) in a few easy steps.
The cut-off machine cart makes it easier
to
repair damaged roadways
–
apply roadway markings
–
cut expansion joints
–
Storing the Machine
If the machine is to remain out of use for
3 months or more:
Drain and clean the fuel tank in a
N
well ventilated place
Dispose of fuel in accordance with
N
all applicable laws and regulations
Remove the abrasive cutting wheel
N
Thoroughly clean the machine
N
Store the machine in a secure and
N
dry place. Protect it against
unauthorized use (e. g., by children)
English
45