•
Loosen the M8 hexagon bolt at the bottom of the wall mount (
(
) and separate the mount arm from the wall plate.
2.
Remove the slide plate from the 3-axis adjustment unit.
•
Remove the M4 × 12 mm hexagon socket head cap bolts (×2) (
•
Remove the slide plate from the 3-axis adjustment unit (
M4 × 12 mm hexagon
socket head cap bolts
(×2)
B
Assemble the parts
1.
Assemble the wall plate.
Assemble the three plates into one unit, and secure them with the M4 × 12 mm hexagon socket head
cap bolts (×6) supplied.
Spring washer
M4 × 12 mm hexagon socket head cap bolts
Washer
19
), then tilt the hexagonal shaft
Hexagonal shaft
M8 hexagon bolt
).
.
Slide plate